Figure 7-4 Replacing The Cover - Sun Microsystems SPARCstation 4 110 Service Manual

Guide cover hinge hooks
into corresponding slots
at front of system chassis.
Replacing the Cover
FIGURE 7-4
3. Replace the lock block on the rear panel. Tighten the Phillips screw that secures
the lock block to the cover.
See .
FIGURE 7-5
4. Tighten the captive Phillips screw in the upper-right corner of the rear panel.
See .
FIGURE 7-5
Caution – Do not use a power driver to tighten captive screws. Do not overtighten
captive screws.
Chapter 7 Internal Access 7-5