Table of Contents
Advertisement
FIGURE 11-24
6. Holding the VSIMM by its edges, remove it from the slot and place it on an
antistatic surface.
11.4.2
Replacing the VSIMM
1. Carefully remove the new VSIMM from its protective packaging and place it on
an antistatic surface.
The bag in which the VSIMM is packed makes a good antistatic surface.
2. Find the VSIMM slot and unlock (press down) the ejector levers at both ends of
the connector.
3. Align the VSIMM with the slot.
See
FIGURE 11-25
at the bottom of the VSIMM line up with the two tabs in the VSIMM connector.
11-22
SPARCstation 4 Model 110 Service Manual • July 1996
Push down ejector
levers to eject VSIMM
Ejecting the VSIMM
. Hold the VSIMM by its edges and orient it so that the two notches
Advertisement
Table of Contents
Troubleshooting
