Figure 8-4 Positioning The Led Cable - Sun Microsystems SPARCstation 4 110 Service Manual

Positioning the LED Cable
FIGURE 8-4
2. Route the speaker/LED cable behind the diskette drive bracket and through the
metal cable clips.
See .
FIGURE 8-3
3. Reconnect the speaker cable connections.
Use needlenose pliers to reconnect the two speaker fast-on connectors.
4. Route the speaker/LED cable under the card guide cable clips.
See .
FIGURE 8-3
5. Reconnect the speaker/LED cable to its connector on the system board.
See .
FIGURE 8-3
6. Thread the CD-ROM SCSI cable and the DC power harness inside the metal cable
clips.
See .
FIGURE 8-3
7. Reinstall the CD-ROM drive.
See Section 9.2.2 "Replacing the CD-ROM Drive" on page 9-6.
8. Detach the wrist strap and replace the cover.
See Chapter 7.
Press LED cable between
tabs to secure it in place.
LED light pipe
Chapter 8 Major Subassemblies 8-7