Installing Accessory Boards; Configuring Accessory Boards With Plug And Play - HP Vectra XM5 3 User Manual

Configuring Plug and
Play with the SETUP
program
3 How to Install Accessories Inside Your PC

Installing Accessory Boards

Installing Accessory Boards
The PC has four accessory board slots:
Slot 1 (the bottom slot) can be used for half-length 16-bit ISA boards
•
Slot 2 can be used for full-length 16-bit ISA boards
•
Slot 3 can be used for either a full-length 32-bit PCI or
•
a full-length 16-bit ISA board
Slot 4 (the top slot) can be used for a half-length 32-bit PCI board.
•

Configuring Accessory Boards with Plug and Play

Plug and Play is an industry standard for automatically configuring
your PC's hardware resources and the accessory boards installed in it.
Your PC has configurable support for Plug and Play in the BIOS.
When you start your PC, the Plug and Play BIOS automatically detects
which hardware resources (IRQs, DMAs, memory ranges, and I/O
addresses) are used by the system-based components.
You can use the SETUP program to select the level of support provided
by the BIOS for Plug and Play-compatible accessory boards:
1 Turn on the PC and press
2 Highlight the
Plug and Play Device Management
or to select
None
If is selected, you must use the ISA Configuration Utility
•
None
(ICU) to configure all accessory boards.
If
•
Boot Only
have the ability to boot (start) your PC will be configured by the
BIOS. You must use the ICU to configure all other accessory
boards.
If is selected, all Plug and Play accessories will be
•
Full
configured by the BIOS. However, if you install a non-Plug and
Play accessory board, you must use the ICU to determine a
conflict-free setting for the board.
3 Press to save your selection and exit from the SETUP program.
32 English
when
<Setup=F2>
, , or
Boot Only
is selected, Plug and Play accessory boards which
appears.
line and use
.
Full