If You Can't Start The Setup Program; If Your Application Software Does Not Work - HP Vectra XM5 3 User Manual

4 Troubleshooting Your PC and Using the SETUP Program
If Your PC Has a Software Problem

If You Can't Start the SETUP Program

This may happen if the copy of the PC's configuration stored in
memory is corrupted. You will need to erase this bad configuration.
To clear the configuration:
1 Switch off the PC and remove the cover (refer to chapter 3).
2 Set the system board switch 3 (CONFG) on the switch block to ON
to clear the configuration (refer to page 91 for the switch location).
3 Switch on the PC to erase the memory.
4 Check that error codes
the PC has started.
5 Switch off the PC.
6 Set the system board switch 3 (CONFG) on the switch block to OFF
to re-enable the configuration.
7 Replace the cover (refer to chapter 3).
8 Switch on the PC and run SETUP by pressing
appears. (Error code
<Setup=F2>
starts.)
9 Press to save the configuration and exit from SETUP.

If Your Application Software Does Not Work

If the PC reports the system is OK but some software won't run, and
the indicator light over the power switch is illuminated:
1 Check to see if the
settings. Refer to the operating system and application software
manuals.
2 If Windows does not run properly, refer to the Windows manual for
guidance.
74 English
and
0240 0130
0130
file is present with the correct
AUTOEXEC.BAT
are displayed, and wait until
when
will appear when the PC