Table of Contents
Advertisement
4 Troubleshooting Your PC and Using the SETUP Program
Using the HP SETUP Program
SETUP Item:
What you can do:
View the SCSI BIOS ROM address for an HP SCSI Accessory Board
SCSI
Disable/Enable shadowing of the SCSI BIOS
Accessory Boards
Configure the flexible disk drives
Choose which flexible disk drive to boot the system from
Flexible Disk Drives
Define if the flexible disk controller is integrated on the system board
or on an accessory board
• Set the System Administrator Password
• Configure your PC to Start With Keyboard Locked
• Enable/Disable Start from Flexible Disk
• Enable/Disable Start from Hard Disk
Security Features
• Enable/Disable the Flexible Disk Drives
• Enable/Disable the Hard Disk Drives
• Allow/Disallow writing to Flexible Disks
• Select the level of support for Plug and Play Accessories
Disable/Enable the Parallel Port
Parallel Port
View I/O address and IRQ channel used by Parallel Port
Select Parallel Port mode Centronics, ECP, EPP 1.7, or EPP 1.9
Disable/Enable the Serial Ports
Serial Port
View I/O address and IRQ channel used by the Serial Ports
Remote Start can be configured as None or Ethernet
Remote Program Load
Select which Protocol will be used
Enable/Disable the PCI integrated Ethernet interface
PCI Integrated Ethernet
View the MAC address
Interface
Select which Video Adapter Mode is used
Video
Enable/Disable the copying of the Video BIOS to RAM for ISA Video
Controllers (the PCI Video BIOS is always shadowed)
Select Video Refresh Rates
VGA
Enhanced/Ergonomic
Modes
View available IRQ channels and select which IRQs are used by
IRQ Map for Accessory
installed accessory boards
Boards
English
79
Advertisement
Table of Contents
