Installing An Accessory Board - HP Vectra VE5 3 Supplementary Manual

Installing an Accessory Board

HP Vectra VL 5/xx series 3 PC
The HP Vectra VL 5/xx series 3 PC has four slots that can be used for installing accessory
boards:
the top slot can be used for a half-length PCI accessory board
the second slot can be used for either a full-length PCI or ISA board
the third slot can be used for a full-length 8- or 16-bit ISA board
the fourth (bottom) slot can be used for a half-length 8- or 16-bit ISA board.
HP Vectra VE 5/xx PC
The HP Vectra VE 5/xx PC has four slots that can be used for installing accessory boards:
the top slot can be used for a full-length 8- or 16-bit ISA board
the second slot can be used for a full-length 8- or 16-bit ISA board
the third slot can be used for a full-length 8- or 16-bit ISA board
the fourth (bottom) slot can be used for a half-length 8- or 16-bit ISA board.
Accessory boards may have preferred locations and special installation instructions – refer
to the manual supplied with the board.
The PC supports Plug and Play through the ISA Configuration Utility and the Configuration
Manager driver in CONFIG.SYS.
NOTE Remember to check that the IRQ, DMA, and I/O addresses for the accessory board
are free - you may have to change the board's settings. Always run SETUP after
installing an accessory board.
VL5/xx & VE5/xx Familiarization Guide PC Hardware Structure 36