Replace The Calibration Insert - Honeywell IntelliDoX User Manual

INTELLIDOX DOCKING MODULE
CRADLE AND CALIBRATION INSERT

Replace the Calibration Insert

To replace the calibration insert, remove the calibration insert from the IntelliDoX (unscrew
the screws and detach the gas tubes), and then install the replacement calibration insert.
1.
2.
3.
4.
5.
HONEYWELL
Disconnect the power cord, network cable, tubing, and inlet filter assemblies from the
IntelliDoX.
Use a screwdriver to unscrew the two screws from the calibration insert.
Detach the two gas tubes from the IntelliDoX.
Remove the calibration insert.
Get the replacement calibration insert.
USER MANUAL || REPLACE DETECTOR
PAGE 95 OF 119