Attach The End Plate - Honeywell IntelliDoX User Manual

INTELLIDOX DOCKING MODULE

Attach the End Plate

The end plate must be attached and locked with the latch arm before connecting power supply
or connecting gas cylinders. The end plate must remain securely latched at all times during
operation. If the end plate is detached during operation, disconnect power and replace the end
plate immediately. Abnormal performance may occur when the end plate is detached or
removed.
Attaching the End Plate
1.
2.
3.
Removing the End Plate
1.
2.
HONEYWELL
Failure to comply may result in incorrect or failed compliance tests or calibrations.
Unlock and raise the latch arm.
Attach the end plate. Verify that the end plate is firmly attached and set flush with the edge
of the module.
Lower and lock the latch arm.
Unlock and raise the latch arm.
Remove the end plate.
USER MANUAL || PREPARE MODULES FOR USE
PAGE 26 OF 119