Elba P90 Instructions For The Use page 9

Fig. 2.3
Fig. 2.4
N.B. When the cooker top is not
being used, set the gas knobs to
their closed positions and also
close the cock valve on the gas
bottle or the main gas supply line.
Caution!
The cooking hob becomes very
hot during operation.
Keep children well out of reach.
LIGHTING GAS BURNERS
FITTED WITH FLAME
FAILURE SAFETY DEVICE
(Dual Burner)
In order to light the burner, you must:
1 – Push and turn the knob (illustrat-
ed in fig. 2.3) in an anti-clockwise
direction (fig. 2.4) up to the
position (maximum rate of inner
crown); push in and hold the knob
until the flame has been lit.
The sparks produced by the lighter
situated inside the relative burner
will light the flame.
In the event that the local gas sup-
ply conditions makes it difficult to
light the burner in
try again with the knob in
tion.
If there is no main electrical supply
connection, bring a lighted match
close to the burner.
2 – Wait for about ten seconds after
the gas burner has been lit before
letting go the knob (safety device
activation delay).
3 – Adjust the gas valve to the desired
position.
If the burner flame should go out for
some reason, the safety valve will auto-
matically stop the gas flow.
To re-light the burner, return the knob to
the closed position (
1 minute and then repeat the lighting
procedure.
Note: To change from using the inner
crown only to using both the inner and
outer crowns together, press the control
knob down before turning it.
You have to do the same when going
from using both crowns to using just the
inner crown.
position,
posi-
), wait for at least
●
9