Elba P90 Instructions For The Use page 25

Built-in cooking hobs
Table of Contents

Advertisement

Available languages

Available languages

REGULATING THE BURNER MINIMUM SETTING
When changing from one type of gas to another, the minimum tap output must also be
correct, considering that in this position the flame must be about 4 mm long and must
remain lit even when the knob is turned sharply from the maximum to the minimum posi-
tion.
The procedure for adjusting the minimum gas rate setting is described below.
Auxiliary, semi-rapid and triple ring burners
– Light the burner.
– Set the gas valve to
position.
– Remove the knob.
– With a thin screwdriver turn the screw F until adjustment is correct (fig. 5.6).
Inside crown of Dual burner
– Light the DUAL burner.
– Set the gas valve to
position.
– Remove the knob.
– Using a screwdriver turn the screw H until the correct setting is obtained (fig. 5.7).
Outside crowns of Dual burner
– Light the DUAL burner.
– Set the gas valve to
position.
– Remove the knob.
– Using a screwdriver turn the screw G until the correct setting is obtained (fig. 5.7).
For G30/G31 gas, tighten the adjustment screw completely.
H
G
H
F
G
Fig. 5.6
Fig. 5.7
25

Advertisement

Table of Contents
loading

Table of Contents