Tips For Setting Up The Hp Ethernet Family Adapter - HP P Class 733/800/866MHz / 1GHz Administrator's Manual

Tips for Setting Up the HP Ethernet Family Adapter

If you want to:
Run SETUP
Save your SETUP selections
Know the PC's MAC address.
Use the PC as a client on the
LAN.
Allow the PC to start from the
operating system on the LAN.
Check the LAN interface.
You need to:
Reset the PC.
When the message
<Setup=F2> appears,
press the F2 key.
From anywhere in the SETUP
program, press ESC until the
Exit menu appears.
Reset the PC.
When the <Setup=F2>
message appears, press the
Esc key.
Run SETUP.
Set an Administrator
Password.
Check the HP Ethernet Family
Adapter configuration.
Make a LAN Disk and install
the drivers.
Run SETUP.
Set an Administrator
Password.
Enable Start from Network.
Make a LAN Disk and install
the drivers. Configure your
server to remote boot your PC.
Run the diagnostic utility as
described later.
1 Setting Up the Network Connection
Tips for Setting Up the HP Ethernet Family Adapter
What happens:
The SETUP menu will appear.
You will be asked to confirm
that you want to save the
settings. Press the Enter key.
The PC will restart.
The MAC address is displayed
with the summary information
(only when the Ethernet
interface is enabled).
When you power-on the PC,
you will be able to log onto the
LAN server.
When you power-on the PC, it
will start from the LAN server.
Refer to "Troubleshooting and
Error Messages" on page 18.
English 17