6 Driver Options - Software Keywords
PCNET Driver-Specific Keywords
PCNET Driver-Specific Keywords
BUSTYPE
If this keyword is specified with one of the options mentioned below, the driver
software will only scan the specified bus for the presence of the PCnet family
device. If this keyword is not specified the driver software will scan all the buses.
FDUP
This keyword will set the 10BASE-T port to operate in Full-duplex mode. This
facility is only available when connected to a Hub which has Full-duplex
capability.
TP
When present, this keyword will force the PCnet device into using the 10BASE-T
port. The PCnet controller will use the 10BASE-T port even if no link beat pulse
is generated from the 10BASE-T hub.
PCNET Driver-Specific Keyword Matrix
Keyword Name
Syntax
Bus Type to Scan
BUSTYPE
BUS_TO_SCAN
Full Duplex
FDUP
Twisted Pair
TP
100
English
Range
PCI
PCI1
PCI2
ALL (Not Present)
- PCI1 is used for mechanism 1.
- Numerical values required with LANtastic driver:
00 (ISA), 01 (PnP), 10 (VESA), 11 (PCI), 12 (PCI1),
13 (PCI2).
UTP
AUI
OFF
Present or Not Present
Default
Not Present
(represents ALL buses)
OFF
Not Present