Ndis 2.01 Driver With Ibm Warp Connect - HP P Class 733/800/866MHz / 1GHz Administrator's Manual

4 Installing Other Network Drivers

NDIS 2.01 Driver with IBM Warp Connect

NDIS 2.01 Driver with IBM Warp Connect
To install the NDIS 2.01 driver under IBM Warp Connect, follow the instructions
below:
1 When you install IBM Warp Connect, you are asked whether you want to install
network support.
If you have already installed Warp Connect without network support, continue
with step 2.
If you are installing Warp Connect now, reply
go directly to step 6.
2 In the OS/2 System folder, open the OS/2 Warp Connect Install/Remove folder.
3 Click on
Warp Connect Selective Install for Networking
4 Choose
Install the product on this workstation (local install)
5 Select
Easy Installation
6 Follow the instructions. You will be offered various network configuration options;
consult the Warp Connect User's Guide for information and continue
installation.
7 In the Select Network Adapter window, click on the
8 When asked for the file location, enter
flexible drive. Click
9 The HP Ethernet Family Adapter driver will be shown in the Drivers Found
window. Select
Ethernet
You should now see the HP Ethernet Family Adapter highlighted in the list of
adapters in the Select Network Adapter window.
10 Insert the Warp Connect CD-ROM. Then click
11 Click in the Select Network Adapter window to accept the adapter.
OK
12 Click again and then click
OK
74 English
.
A:\OS2
.
OK
as Type of LAN.
a second time in the configuration window.
OK
to install network support, and
Yes
.
Other Adapter
and insert the LAN Disk into the
.
OK
.
window.