Parallel Transferring Odi Driver With Dos Shell - HP P Class 733/800/866MHz / 1GHz Administrator's Manual

Parallel Transferring ODI Driver with DOS Shell

To install the ODI driver for DOS, follow the instructions below:
1 To begin the installation you require the Novell DOS Shell installation diskette
2 Create a directory on the DOS boot drive (for example C) for the HP and NetWare
3 Copy the DOS ODI Driver and NET.CFG File. For example, if the LAN Disk is in
4 Copy the following files from the Novell installation diskette labeled "WSGEN" to
5 The installation of the Parallel Transferring DOS ODI driver and NetWare client
NOTE The DOS Shell can only access a server's bindery. If you want access any enhanced
NetWare Directory Services, you should use the DOS Requester (VLM).
labeled 'WSGEN' and the LAN Disk.
files using the following commands at the DOS prompt:
C:
MKDIR C:\NOVELL
Drive A use the following commands:
COPY A:\NOVELL\LAPPCLNT\PCLAPP.COM C:\NOVELL
COPY A:\NOVELL\LAPPCLNT\NET.CFG C:\NOVELL
The contents of the NET.CFG file are given below:
LINK DRIVER PCLAPP
BUSTYPE PCI1
FRAME ETHERNET_802.3
LED2 90
the directory:
C:\NOVELL
LSL.COM (must be version 2.11 or later)
IPXODI.COM (must be version 2.20 or later)
NETX.EXE
These files are either in the root or the DOSODI directory on the NetWare
diskette.
software is complete. Refer to page 40 for information on how to start a Parallel
Transferring NetWare client.
2 Installing Novell NetWare Drivers
Parallel Transferring ODI DOS Client Driver
English 39