HP P Class 733/800/866MHz / 1GHz Administrator's Manual page 91

Loading the Remote
Before loading RPL.NLM, create the BOOTCONF.SYS file as described above and
install the Novell server with an 802.2 frame type and then load RPL.NLN.
Program Load
Services
Load RPL.NLM in the same manner as any other NetWare NLM. At the server
command line prompt, type:
Then bind RPL.NLM with your driver. For example:
where:
BIND
RPL
board
The IEEE 802.2 frame types are as follows:
ETHERNET_802.2 Ethernet (802.3) using an 802.2 envelope.
TOKEN_RING
FDDI_802.2
BIND Parameters
optional, not case sensitive, can be separated by blanks or commas, and may be
entered in any order.
NOTE GNS is required if you have an SFT III installation.
LOAD RPL
(there are no parameters associated with loading RPL.NLM)
BIND RPL to board [ACK],[FRAME=xx],[GNS],[NODEFAULT],
[PROTECT],[PS=SERVER]
This is the command used to link the LAN
drivers to the communications protocol. (Refer
to the Novell NetWare manual for details)
The name of a NetWare loadable module
protocol used for remote boot.
The name of any NetWare LAN server driver that
is configured for the IEEE 802.2 frame type.
Token-Ring (802.5) using an 802.2 envelope.
FDDI using an 802.2 envelope.
. The parameters specified between square brackets [ ] are
5 Configuring for Remote Boot
Setting Up a Novell NetWare 3.x and 4.x Server for Remote Start
English 91