HP Kayak XW U3-W3 Installation Manual page 20

Before Installing an
IDE Device
Before Installing a
SCSI Device
HP Kayak XW U3 & W3 PC Workstation — Installing Accessories In Your HP PC Workstation
Installing Mass Storage Devices
Refer to the drive's installation guide to see if you must set jumpers or
if there is a special installation procedure to follow.
If you are installing a SCSI device, refer to the section "Before Installing
a SCSI Hard Disk" on page 13 before using the following instructions.
1 Disconnect the computer's power cord and any telecommunications
cable.
2 Remove the computer's cover (refer to page 3).
3 Slide out the power supply to provide better access to the disk drive
cables (see page 6).
4 If installing a drive in a 5.25-inch wide shelf, remove the drive tray
and put it in a safe place.
5 Slide the drive into the shelf.
6 Secure the drive in position using the screws provided with the
drive.
7 Locate the appropriate data cable for the device.
20 English
Secure the drive Mounting Rails
in position
Remove the
drive tray if
installing a
5.25-inch drive
Slide the drive
into position