HP Kayak XW U3-W3 Installation Manual page 28

Completing the
Installation of a
Processor
NOTE
1.
NOTE
HP Kayak XW U3 & W3 PC Workstation — Installing Accessories In Your HP PC Workstation
Installing a Processor
1 Verify that the system board bus speed switches are correctly
configured for the processor.
If two processors are installed, both must operate at the same bus speed
and processor speed. Refer to the manual supplied with the processor
to verify which bus and processor speeds are supported.
Switch 1 Switch 2
1
UP UP
UP UP
UP UP
UP UP
UP=OFF, DOWN=ON.
2 Install any other accessories before completing the installation of
the processor.
3 Replace the cover (refer to page 4).
4 Turn on the computer and check that the new processor is
recognized by the power-on system-test.
To fully benefit from dual processing, you will need to re-install
Windows NT 4.0 on your PC Workstation.
28 English
Switch 3 Switch 4
UP DOWN
DOWN UP
DOWN UP
DOWN DOWN
Switch 5 External Bus
Speed
DOWN 100 MHz
UP 100 MHz
DOWN 100 MHz
UP 100 MHz
Processor
Speed
350 MHz
400 MHz
450 MHz
500 MHz