HP Kayak XW U3-W3 Installation Manual page 25

Completing the
Installation of an ISA
Accessory Board
NOTE
HP Kayak XW U3 & W3 PC Workstation — Installing Accessories In Your HP PC Workstation
7 Secure the board by replacing the slot cover screw.
If you loosened the screws on adjacent slots, remember to tighten
them.
Secure the board
in position
8 Install any other accessories before replacing the cover (refer to
page 4). Reconnect all cables and power cords.
If you have installed an ISA accessory board that uses any interrupt,
you must run the Setup program and reserve the IRQ for the
accessory board. This allows PCI devices to be automatically
configured.
1 Turn on the PC Workstation and press
appears.
2 In the Setup program, select the Advanced menu and the PCI Slot
Configuration submenu. A list of IRQs and the devices that use them
are displayed. Highlight the IRQ field you want to change, for
example
IRQ 11
3 You can use the space bar or press
available for PCI (
( ).
Reserved
4 Press to save any changes you made and exit the Setup
program.
You should always leave at least one IRQ available for use by the
integrated PCI devices.
.
) or make it unavailable for PCI
Available
Installing Accessory Boards
when
Setup
or to make the IRQ
English
25