Tesla AquaStar AQ500 Manual page 71

SELF-CLEANING THE MICROFIBRE BRUSH
CLEANING THE MICROFIBRE BRUSH
In order to achieve optimal performance, clean the microfibre brush and its cover after each use of the
appliance. Grasp the front handle of the cover, simultaneously press the release button and pull
upwards to remove the cover. Rinse it with water. Grasp the brush roller by the tab and pull upwards to
remove it. Remove hair and dirt wrapped around the roller with the 3in1 cleaning tool. Rinse it with
water. Allow it to dry before reinstalling it. Reinsert the brush roller and cover.

For optimal performance, use the quick self-cleaning function of
the microfibre brush regularly after each clean.

Place the appliance in the Storage base. The clean water tank
should be at least 1/3 full of water.

Press and hold the „ON" button for 3 seconds to start
self-cleaning mode. The appliance will switch off automatically
once self-cleaning is complete. The whole process takes
approximately 40 seconds.

Empty the Dirty water tank before and after self-cleaning.
Push hook (1) into hole (1) to lock it into place, then push hook
(2) into hole (2) to lock it into place. Always snap the brush
cover into the right place to prevent loss of suction or water
leakage.
Do this carefully to avoid damaging the cover.