Fpga U1 Fci Airmax Interlaken Connectors - Xilinx ML630 User Manual

FPGA U1 FCI Airmax Interlaken Connectors

Figure 1-2
The ML630 board provides four sets of FCI Airmax male/female (plug/receptacle)
connector pairs implementing the Interlaken protocol.
Note:
following documents located on the Interlaken Alliance website (http://www.interlakenalliance.com):
Protocol: Interlaken Protocol Definition v1.x and Connector Pinouts: Interlaken Interop
Recommendations v1.x. The Protocol Definition document also discusses the flow control functions
provided by the TX and RX FC_CLK, FC_DATA and FC_SYNC connector pins.
Three sets of connector pairs (P1/J1, P2/J2, and P3/J3) are wired to FPGA U1.
through
the ML630 schematic, page 2, for an overview of the connectivity shown in these tables.
ML630 Board User Guide
UG828 (v1.0) September 28, 2011
callout [31, 32, 34]
The Interlaken protocol definition and recommended connector pinouts can be found in the
Table 1-24 show FPGA U1 to FCI connector details. Refer to the block diagram on
www.xilinx.com
Detailed Description
Table 1-19
25