Table of Contents
Advertisement
Echoflex Installation Guide
Light Sensor
1.
Press and hold the [MODE] button for 3 seconds. The Mode/Sensor
Count LED will turn solid amber and the "A" (Auxiliary) button on the
front of the Light Sensor controller will begin to blink the number of
times that corresponds to the preset number used for the dark action.
2.
Press the "A" button the desired number of times to set a new preset
for recall. The "A" button LED will blink to indicate the number of the
preset that will be used for the dark action.
3.
Press the [MODE] button to save the current setting. The Mode/Sensor
Count LED will turn off and the "A" button LED will blink to indicate
the saved preset value.
Attach Sensor
Attach the sensor to the mounting plate by aligning the tabs on the sensor
with the slots on the mounting plate, and then twist clockwise until the two
are locked into place.
Record Target
The "Record Target" button takes a snapshot of
the current light (lux) settings, which determines
the amount of light the sensor should maintain.
Press the "Record Target" button. A 10 second
timer begins and a red LED illuminates,
indicating the record process.
Once the 10 second timer finishes, the
•
current measured lux value records as the
target (threshold) value.
The LED will blink twice when the target
•
(threshold) value is successfully recorded.
Pressing "Record Target" again during the 10 second timer will cancel
•
the record process.
Sensor Operation
Dimming and Switched Light Sensor operation settings only apply in Basic
config mode (DIP switch 2 is set to "Off"). When in Custom config mode (DIP
switch 2 is set to "On") settings applied from ElahoAccess are used instead.
Light Sensor
Page 11 of 12
Record
target
Auxiliary
button
button
Echoflex
Advertisement
Table of Contents
