Symptoms And Solutions; You Cannot Turn On The Projector - Canon WUX6000 User Manual

LED indicator
status
WARNING
(only) flashes 5
times
repeatedly.
WARNING
(only) flashes 3
times
repeatedly.
WARNING
(only) flashes 6
times
repeatedly.

Symptoms and Solutions

■ You Cannot Turn on the Projector

Cause
The power cord is not
connected correctly.
The power cord has just
been connected.
The lamp cover is open.
The safety device is
activated because the air
intake or the exhaust
vent is blocked and the
internal temperature of
the projector has
increased.
Downloaded From projector-manual.com Canon Manuals
Meaning
Faulty power Abnormal voltage is applied to some parts in the
supply power supply or another failure may have
occurred. Unplug the projector from the electrical
outlet, then plug it back into the outlet and turn on
the projector again. Contact the Canon Customer
Support Center if the same warning occurs
again.
Filter error The air filter is not installed. Check whether or not
the air filter is installed correctly. Contact the
Canon Customer Support Center if the same
warning occurs again.
Faulty lens The lens cable is not connected to the lens unit
connector correctly. Unplug the projector, connect the lens
cable to the lens unit correctly, and then plug the
projector in again. Contact the Canon Customer
Support Center if the same warning occurs
again.
Check whether the power cord is connected
correctly. (P138)
Wait at least one second after plugging the projector
in until you press the POWER button. You cannot
turn the projector on immediately after plugging it in.
(P38)
Unplug the projector from the power outlet, then
install the lamp cover correctly and turn on the
projector again.
When the safety device is active, the [POWER ON]
indicator does not turn on when you connect the
power cord. You cannot disable this safety device.
Remove any obstacle that is blocking the air intake or
exhaust vent and contact the Canon Customer
Support Center.
Countermeasure
Countermeasure
203
Troubleshooting