Table of Contents
Advertisement
Instructions for use KaVo EDUnet ULTRA HD
4 Assembly | 4.1 Connecting participant boxes
4 Assembly
A participant box is needed for each set of two work-stations in the network. The parti-
cipant box is placed between the connections of the computer to the monitor, key-
board, and mouse.
The participant boxes establish the connection between the individual participant
work-stations and the teacher station and are connected to each other through the
EDUnet bus cable.
The participant boxes carry all connectors for one work-station on each side: two
HDMI sockets for connection of monitor and graphics board of the computer as well as
USB ports for mouse and keyboard.
Optionally, TID and audio boxes can be connected.
Each participant box must be connected to a power supply.
4.1 Connecting participant boxes
Note
Installed in a cable channel, a sufficient safe distance from other power conducting
lines must be maintained in accordance with IEC 61010-1.
▶ Affix the participant box under the table top with the fastening clip.
or
▶ Put the participant box directly in a cable channel.
▶ Connect the HDMI-HDMI (for audio), HDMI-DP and USB connecting cable to the
designated connectors on the participant box.
▶ Connect the corresponding output of the graphics board of the PC to the HDMI-
DVI cable of the participant box.
▶ Connect the UCB cable to the corresponding USB port of the PC. Please note that
only one USB cable per PC is required, since the participant box is recognised as
a combination device (mouse and keyboard) by the PC.
▶ Connect mouse, keyboard, and monitor to the designated connectors of the parti-
cipant box.
▶ Connect the power supply to the participant box and plug it into the mains.
16 / 52
Advertisement
Table of Contents
