System Administration; System Programming And Diagnosis With Personal Computer - Panasonic KX-TD816JT Features Manual

1.2 System Administration

1.2 System Administration
System Programming and Diagnosis with
Personal Computer
Description
This system can be programmed and administered using a personal computer (PC). The Serial
Interface/Remote Programming & Diagnosis Manual and its floppy disk are required to
perform this feature. There are two programming methods:
Method
On-Site
Programming
Remote
Programming
Conditions
• A proprietary telephone can also be used to perform System Programming.
• Access to System Programming is allowed only one at a time.
• To access system administration, a valid password must be entered. The password is
factory-programmed and can be changed. <[107] System Password>
14
Using the Serial By connecting a PC to the system using the Serial Interface
Interface (RS-232C) port, system programming and maintenance can
(RS-232C) port be performed locally.
The main unit has an Serial Interface (RS-232C) port which
can be used for either system administration or Station
Message Detail Recording (SMDR).
Using a modem By connecting a PC to the system using a modem, system
programming and maintenance can be performed locally.
Install the optional Remote Card or Unit. Connect the PC to
an extension jack. Assign the floating number of the modem.
<[813] Floating Number Assignment> Dial this number
from the PC.
You can perform system programming and maintenance from a remote site using
a PC. Install the Remote Card or Unit and assign the floating number of the
modem. <[813] Floating Number Assignment>
Starting system administration from a remote location can be done in the
following ways.
• Call an extension (probably the operator) from a remote location and request
a transfer to the modem.
• Dial the floating number of the modem using the Direct Inward System
Access (DISA) feature.
• Assign the modem as the destination of the Direct In Lines (DIL) 1:1 feature.
Description
Features Guide