Panasonic KX-TD816JT Features Manual page 70

1.5 Attended Features
Sequence Examples
1T TR N/A
N/A: not available for assignment.
Note
• The UCD Time Table is not available for incoming extensions or transferred calls.
• If the overflow extension or Time Table number is not assigned, the system will not answer
the call and waits for an idle extension. In this case, IRNA will be employed.
• If the system sends the OGM after queuing, the OGM answering time is subject to the time
assigned. <[213] DISA Delayed Answer Time>
• Dialling is disregarded during the OGM.
• In sequence assignment, "Sx" can be assigned to a space other than the first only when
another "Sx" is assigned in the first space.
• In sequence assignment, an assignment after "TR", "RT" or "Blank" is not available.
• If a timer is the first item in a Time Table sequence, it will delay answering according to the
Timer's setting. The caller will hear a ringback tone.
• Music on Hold after an OGM can be changed to a ringback tone. <[990] System Additional
Information, Area 01-Bit 1>
Conditions
• UCD can be used in the following cases:
a)
The floating number of UCD is assigned as the Direct In Lines (DIL) 1:1 destination.
b)
The floating number of UCD is assigned as the Intercept Routing destination.
c)
The floating number of UCD is dialled from an extension.
d)
The floating number of UCD is dialled from DISA (Direct Inward System Access).
e)
The floating number of UCD is assigned as the UCD Overflow destination.
• This feature requires assigning an UCD for an extension group. <[106] Station Hunting
Type> An extension cannot belong to two or more UCD groups.
• The floating number can be assigned on an UCD group basis. The UCD group is based on
the extension group. <[813] Floating Number Assignment>
• It is possible to set the log-in or log-out status on an extension basis. An UCD call can be
sent to an extension in log-in status within the UCD group, but cannot be sent to extensions
in log-out status. If the extension would like to leave the group temporarily, the extension
sets the log-out status by the feature number to prevent UCD calls being sent to his/her
extension. When the extension re-joins the group, the extension sets the log-in status.
• There should be at least one extension that is in log-in status.
70
Sequence Activation Examples
Waits for an idle extension for 16 seconds and then transfers to
N/A N/A
an overflow extension.
Activation
Features Guide