Platform Control Station - JLG E600J Operation And Safety Manual

14. Indicator Gauge
Registers the amount of time the machine
has been in use, with functions operating. In
the event of a fault, the hourmeter also dis-
plays the three digit fault code. Refer to the
Service Manual for a listing of fault codes. Additionally, there
is a small, red indicator light that will blink when there is a
fault on the machine to draw operator attention to the dis-
play.
15. Platform Overload (If Equipped)
Indicates the platform has been overloaded.
3121710
SECTION 3 - MACHINE CONTROLS AND INDICATORS

Platform Control Station

(See Figure 3-2., Platform Control Station)
1. Power/Emergency Stop
A two-position red mushroom shaped switch
furnishes power to PLATFORM Controls when
pulled out (on). When pushed in (off ), power is
shut off to the platform functions.
Within about 2 seconds of pulling the switch out, the
machine will perform a diagnostic check of the various elec-
trical circuits, and if everything is OK, the platform alarm will
beep once. During this time the lights on the indicator panel
will also blink once as a bulb check.
TO AVOID SERIOUS INJURY, DO NOT OPERATE MACHINE IF ANY CONTROL LEVERS OR
TOGGLE SWITCHES CONTROLLING PLATFORM MOVEMENT DO NOT RETURN TO THE
OFF OR NEUTRAL POSITION WHEN RELEASED.
3-5