JLG E600J Operation And Safety Manual page 54

SECTION 3 - MACHINE CONTROLS AND INDICATORS
1. Tilt Alarm Warning Light and Alarm
This orange illuminator indicates that the
chassis is on a slope. An alarm will also sound
when the chassis is on a slope and the boom
is above horizontal. If lit when boom is raised
or extended, retract and lower to below horizontal then
reposition machine so that it is level before continuing oper-
ation. If the boom is above horizontal and the machine is on
a slope, the tilt alarm warning light will illuminate and an
alarm will sound and CREEP is automatically activated.
IF TILT WARNING LIGHT IS ILLUMINATED WHEN BOOM IS RAISED OR EXTENDED,
RETRACT AND LOWER TO BELOW HORIZONTAL THEN REPOSITION MACHINE SO THAT
IT IS LEVEL BEFORE EXTENDING BOOM OR RAISING BOOM ABOVE HORIZONTAL.
2. Platform Overload (If Equipped)
Indicates the platform has been overloaded.
3-12
3. System Distress Light
The system distress light indicates an abnor-
mal condition for machine control system.
The three likely causes of a system fault are:
a. The seven second enable time has been allowed to
lapse or a function was selected before pushing down
the footswitch.
b. The maximum power limit has been reached and the
machine is not moving. This condition is the same as
stalling the engine by asking it to provide more power
than it was designed to do.
c. There is some other fault in one of the circuits. Refer to
the service manual.
4. Drive Orientation Indicator
When the boom is swung beyond the rear
drive tires or further in either direction, the
Drive Orientation indicator will illuminate
when the drive function is selected. This is a
signal for the operator to activate the Drive Orientation
Override Switch and verify the drive control direction is cor-
rect.
3121710