JLG E600J Operation And Safety Manual page 45

2. Jib Rotate (If Equipped)
A three position switch permits rotation of
the jib and platform.
ONLY USE THE PLATFORM LEVELING OVERRIDE FUNCTION FOR SLIGHT LEVELING OF
THE PLATFORM. INCORRECT USE COULD CAUSE THE LOAD/OCCUPANT TO SHIFT OR
FALL. FAILURE TO DO SO COULD RESULT IN DEATH OR SERIOUS INJURY.
3. Platform Leveling Override
A three position switch allows the opera-
tor to adjust the automatic self leveling
system. This switch is used to adjust plat-
form level in situations such as ascend-
ing/descending a grade.
4. Jib Lift (If Equipped)
This switch provides raising and lowering
of the jib.
3121710
SECTION 3 - MACHINE CONTROLS AND INDICATORS
5. Function Enable
The enable switch must be held "DOWN" to
enable all boom controls when the engine is run-
ning.
6. Boom Lift
Provides for raising and lowering of the
Boom.
NOTE: Refer to the Service Manual for the generator fault codes.
7. Generator/Engine Start Button (if equipped)
The generator/engine start push-button switch
allows the generator to be started manually to top-
off the battery charge. The generator will start automatically
when the batteries reach a low-charge level.
3-3