Mitsubishi Heavy Industries L2 Service Manual page 85

OIL FILTER AND OIL PRESSURE SWITCH
Figure 88 Installing oil filter
Figure 89 Installing pressure switch
Figure 90 Inspecting oil filter and oil pressure switch
84 / 155
19.2 Removal and installation
1. Remove the filter by the filter wrench.
2. Remove the oil pressure switch by the special tool
named socket wrench.
Special tool name
Socket wrench
Table 38 Special tool
3. Apply engine oil to the O-rings. Pay attention not to
twist the O-rings.
4. Apply sealant (HERMESEAL H1 or THREE-BOND
1314) to the threads of the oil pressure switch
before installation.
5. Install the oil filter by hands.
CAUTION
After installation, check for oil leak while the engine is
running.
19.3 Inspection
Inspect the following.
19.3.1 Oil leak
Pressure switch ON
pressure
:
Table 39 Pressure
CAUTION
Check the oil filter for contamination. If necessary,
clean the engine interior with flushing oil.
ENGLISH
LUBRICATION SYSTEM
Part No.
MD998054
0.05±0.01 MPa
(0.5±0.1 kgf/cm
[7.11±1.42 psi]
Service Manual Mitsubishi L-Series diesel engines
2
)
Version 08/2004