Mitsubishi Heavy Industries L2 Service Manual page 141

KEY-OFF STOP SYSTEM
Red
White
Blue
Figure 153 Fuel cutoff solenoid (ETR type) diagram
140 / 155
Pull
Hold
ENGLISH
ELECTRICAL SYSTEM
Description
Stroke
Rated current, pull
Rated current, hold
35.4.2 Solenoid installation
In this solenoid, under the switch key is turned to the
OFF position, the solenoid shaft is pulled in when the
solenoid is functioned and the shaft is returned
(protruded). Install the solenoid while it is not
functioned (its shaft is protruded), using the same
procedure as mentioned before for the push type, so
that the specified clearance between the solenoid shaft
and injection-pump rack can be obtained.
NOTE
It will take about 10 seconds to restart an engine
which was shut down by the key shutoff device.
Service Manual Mitsubishi L-Series diesel engines
Specification
13.5±0.5 mm
[0.5315±0.0197 in.]
55A
1A
Version 08/2004