Safety Notes - SMART Embedded Computing RTM-ATCA-F140 Series Installation & Use Manual

Table of Contents

Advertisement

Safety Notes

This section provides warnings that precede potentially dangerous procedures throughout
this manual. Instructions contained in the warnings must be followed during all phases of
operation, service, and repair of this equipment. You should also employ all other safety
precautions necessary for the operation of the equipment in your operating environment.
Failure to comply with these precautions or with specific warnings elsewhere in this manual
could result in personal injury or damage to the equipment.
SMART Embedded Computing (SMART EC) intends to provide all necessary information
to install and handle the product in this manual. Because of the complexity of this product
and its various uses, we do not guarantee that the given information is complete. If you
need additional information, ask your SMART EC representative.
The product has been designed to meet the standard industrial safety requirements. It must
not be used in safety critical components, life supporting devices, or on aircraft.
Only personnel trained by SMART EC or persons qualified in electronics or electrical
engineering are authorized to install, remove, or maintain the product. The information
given in this manual is meant to complete the knowledge of a specialist and must not be
used as replacement for qualified personnel.
Keep away from live circuits inside the equipment. Operating personnel must not remove
equipment covers. Only factory authorized service personnel or other qualified service
personnel may remove equipment covers for internal subassembly or component
replacement or any internal adjustment.
Do not install substitute parts or perform any unauthorized modification of the equipment or
the warranty may be voided. Contact your local SMART EC representative for service and
repair to make sure that all safety features are maintained.
EMC
The product has been tested in a standard SMART EC system and found to comply with
the limits for a Class A digital device in this system, pursuant to part 15 of the FCC Rules,
EN 55032 Class A respectively.
These limits are designed to provide reasonable protection against harmful interference
when the product is operated in a commercial, business or industrial environment.
The product conducts, radiates and uses radio frequency energy and, if not installed
properly and used in accordance with this user documentation, may cause harmful
interference to radio communications.
Operating the product in a residential area is likely to cause harmful interference. If this
occurs, the user will be required to correct the interference at the user's expense.
RTM-ATCA-F140 Series Installation and Use (6806800M97M)
15

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RTM-ATCA-F140 Series and is the answer not in the manual?

This manual is also suitable for:

Rtm-atca-f140Rtm-atca-f140-d

Table of Contents