Save】Button; Load】Button - RGBlink GX4pro User Manual

Table of Contents

H POS: set the horizontal position of image

V POS: set the horizontal position of image

RESET: If operation is not proper, turn knob to <RESET> and start over.

3.4.4【SAVE】Button

Push the [SAVE] button, the button light is on, and enable the SAVE function.

LCD shows [SAVE] instruction info to assist users complete operation. Meanwhile, part of numeral buttons 0~9

lights are on and parts flash.. Buttons with lights on are empty, flashing buttons are used. LCD shows as below.

Saving to flashing positions will overwrite previously saved settings. For example, button 1 is flashing, after

pressing button 1, LCD shows.

Push knob to confirm,【MENU】to cancel.

Up to 10 groups of SAVE can be done from SAVE1 to SAVE 10

3.4.5【LOAD】Button

Push 【LOAD】LCD shows the instruction information to assist users complete LOAD operation.

Meanwhile, among numeral buttons 0-9, some buttons lights are on, some flash and perhaps some lights go off.

Buttons with light on indicate the <SAVE> ready to load, flash indicate the

indicate no <SAVE> to load. For example button 1 light is on, press button 1 to load <SAVE1>

LCD shows below:

Push【MENU】to exit LOAD, the button lights go out.

Ph: +86 0592 5771197 | support@rgblink.com | www.rgblink.com

SAVE TO

>SAVE1

KEY ON FOR EMPTY

FLASH IS FOR USED

Save 1 used, overwrite

Yes<OK>, NO <MENU>

LOAD FROM

>SAVE1 FINISHED！

KEY ON FOR ALL SAVES FLASH IS CURRENT SET

<SAVE> is currently loaded, light off

Table of Contents