Table of Contents
Advertisement
7. Select【horizontal or vertical lines】according to the actual bright line direction of display screen.
Number of bright rows on display:according to the LED screen
Number of spaced rows:When only one line is lit on the screen,the number of rows between must be selected.
8. Observe the position of the bright spot on the first module of the LED screen, and click the corresponding grid.
If you make a mistake,click【back】to the last step or【reset】to restart.
If you select 【 Profiled lamp board(with taps) 】 in 5th step,you need to click blank spots.Observe the first
module,and click【unbright spot(blank spot)】if no flash spot appears.
After the settings, a prompt will pop up. Click【OK】and then click【Finish】to confirm.
9. After 【 Smart Settings】 ,it will return to 【Receiving card】 interface and set a new parameters for receiving cards.
①Fill in the total Width/Height of box.
There is no need to adjust other parameters if the image of the single receiving card is normal.
②It is recommended to change【grayscale series】and【low ash effect】to change the refresh rate.
③Send to receive card:Each time you change the parameters, you can click【Send to receive card】and observe
the change of the screen.
④Save to the receive card:After debugging,click【Save to the receiving card】and the data will not be lost after
power off and restart.
© Xiamen RGBlink Science & Technology Co., Ltd.
39
Ph: +86 0592 5771197 | support@rgblink.com | www.rgblink.com
Advertisement
Table of Contents
