Supermicro SuperServer SYS-1029U-TN12RV User Manual page 99

Chapter 6: UEFI BIOS
Above 4G Decoding (Available if the system supports 64-bit PCI decoding)
Select Enabled to decode a PCI device that supports 64-bit in the space above 4G Address.
The options are Disabled and Enabled.
SR-IOV Support
Use this feature to enable or disable Single Root IO Virtualization support. The options are
Disabled and Enabled.
MMIO High Base
Use this feature to select the base memory size according to memory-address mapping for
the IO hub. The options are 56T, 40T, 24T, 16T, 4T, and 1T.
MMIO High Granularity Size
Use this feature to select the high memory size according to memory-address mapping for
the IO hub. The options are 1G, 4G, 16G, 64G, 256G, and 1024G.
PCI PERR/SERR Support
Select Enabled to activate PCI Error and System Error report handling. The options are
Disabled and Enabled.
Maximum Read Request
Select Auto to allow the system BIOS to automatically set the maximum read request size
for a PCI-E device to enhance system performance. The options are Auto, 128 Bytes, 256
Bytes, 512 Bytes, 1024 Bytes, 2048 Bytes, and 4096 Bytes.
MMCFG Base
Use this feature to select the default value for the PCI MMIO (Memory-Mapped IO) base
address. The options are 1G, 1.5G, 1.75G, 2G, 2.25G, and 3G.
NVMe Firmware Source
Use this feature to select the NVMe firmware to support booting. The options are Vendor
Defined Firmware and AMI Native Support. The default option, Vendor Defined Firmware,
is pre-installed on the drive and may resolve errata or enable innovative functions for the
drive. The other option, AMI Native Support, is offered by the BIOS with a generic method.
VGA Priority
Use this feature to select the graphics device to be used as the primary video display for
system boot. The options are Onboard and Offboard.
AOC-URN4-m2TS SLOT1 PCI-E 3.0 X16 OPROM (Available when the device is
detected by the system)
RSC-R1UW-2E16 SLOT1 PCI-E 3.0 X16 OPROM
RSC-R1UW-2E16 SLOT2 PCI-E 3.0 X16 OPROM
RSC-R1UW-E8R SLOT1 PCI-E 3.0 X8 OPROM
99