Supermicro SuperServer SYS-1029U-TN12RV User Manual page 97

SATA Device Type (SATA Port 0~ Port 7)
Use this feature to specify if the SATA port specified by the user should be connected to a
Solid State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State
Drive.
PCH sSATA Configuration
sSATA Controller
This feature enables or disables the onboard SATA controller supported by the Intel® PCH
chip The options are Enable and Disable.
.
Configure sSATA as
Select AHCI to configure a SATA drive specified by the user as an AHCI drive. Select RAID
to configure a SATA drive specified by the user as a RAID drive. The options are AHCI and
RAID.
SATA HDD Unlock
Select Enable to unlock the HDD password. The options are Disable and Enable.
Aggressive Link Power Management
When this feature is set to Enable, the SATA AHCI controller manages the power usage of
the SATA link. The controller will put the link to a low power state when the I/O is inactive for
an extended period of time, and the power state will return to normal when the I/O becomes
active. The options are Disable and Enable.
*If the feature, Configure sSATA as, is set to AHCI, the following features will become
available for user's configuration:
sSATA Port 0~ Port 5
This feature displays the information detected on the installed SATA drive on the particular
SATA port.
•
Model number of drive and capacity
•
Software Preserve Support
Hot Plug (sSATA Port 0~ Port 5)
Select Enabled to enable a SATA port specified by the user. The options are Disable and
Enable.
Spin Up Device (sSATA Port 0~ Port 5)
On an edge detect from 0 to 1, set this feature to allow the PCH to initialize the device.
The options are Disable and Enable.
97
Chapter 6: UEFI BIOS