Supermicro SuperServer SYS-1029U-TN12RV User Manual page 201

F.2 Enabling NVMe RAID
RAID for NVMe SSDs must be enabled through the UEFI BIOS.
1. Install the patch as described in the Restrictions and Requirements section on a
previous page.
2. Reboot the server.
3. Press [DEL] key to enter BIOS.
4. Switch to Advanced > Chipset Configuration > North Bridge > IIO Configuration >
Intel® VMD Technology > CPU1 & CPU2.
5. Enable the VMD according to the following rules.
•
For U.2 NVMe, enable all the sub-items under each PStack, based on the your model
server:
CPU1
VMD Config for PStack0
VMD Config for PStack1
•
For M.2 NVMe or NVMe AIC, enable the VMD according to which AOC card/slot it used.
An example U.2 configuration follows.
CPU1 Configuration
VMD BIOS Setting for 1029U-TN12RV
CPU2
VMD Config for PStack0
VMD Config for PStack2
CPU2 Configuration
Figure F-2. BIOS VMD Setting Example
201
Appendix E: CPU-Based RAID for NVMe