Troubleshooting; Wiring Diagram - Axminster AS408 User Manual

Troubleshooting...

W
A X M I N S T E R
W H I T E
PROBLEM
Motor will not run.
Machine slows down while
sanding.
Sanding belt runs off pulleys. 1. Belt NOT tracking properly. 1. Adjust tracking (See page
Wood burns while sanding.
23
POSSIBLE CAUSE
1. Defective or broken
"ON -OFF" switch.
2. Defective or damaged
switch cord.
3. Defective or damaged
switch relay.
4. Burned out motor.
5. Blown fuse.
1. Applying to much pressure
to workpiece.
1. Sanding disc or belt is
worn.
2. Excessive pressure being
applied to workpiece.
REMEDY
1-3. Replace all broken or
defective parts before using
the sander.
4. Contact Axminster Tool
Centre on 0800 371822 &
asked to be transferred to
the"Technical Sales"
department.
1. Apply less pressure to
sanding surface.
21) on how to track the belt.
1. Replace the disc or belt.
2. Reduce pressure being
applied to workpiece.

Wiring Diagram