Hardware Interface; Gige Connector; Power Supply Connector - Photon Focus MV1-D4096 Series User Manual

Hardware Interface

6.1 GigE Connector

The GigE cameras are interfaced to external components via
• an Ethernet jack (RJ45) to transmit configuration, image data and trigger.
• a 12 pin subminiature connector for the power supply, Hirose HR10A-10P-12S (female) .
The connectors are located on the back of the camera. Fig. 6.1 shows the plugs and the status
LED which indicates camera operation.
S t a t u s L E D
Figure 6.1: Rear view of the GigE camera

6.2 Power Supply Connector

The camera requires a single voltage input (see Table 4.4). The camera meets all performance
specifications using standard switching power supplies, although well-regulated linear power
supplies provide optimum performance.
It is extremely important that you apply the appropriate voltages to your camera.
Incorrect voltages will damage the camera.
MAN069 12/2018 V1.1
- t h e r n e t J a c k ( R J 4 5 )
6
P o w e r S u p p l y
a n d I / O C o n n e c t o r
79 of 123