Table of Contents
Advertisement
Hardware Interface
7.1 GigE Connector
The GigE cameras are interfaced to external components via
•
an Ethernet jack (RJ45) to transmit configuration, image data and trigger.
•
a 12 pin subminiature connector for the power supply, Hirose HR10A-10P-12S (female) .
The connectors are located on the back of the camera. Fig. 7.1 shows the plugs and the status
LED which indicates camera operation.
S t a t u s L E D
Figure 7.1: Rear view of the GigE camera
7.2 Power Supply Connector
The camera requires a single voltage input (see Table 4.4). The camera meets all performance
specifications using standard switching power supplies, although well-regulated linear power
supplies provide optimum performance.
It is extremely important that you apply the appropriate voltages to your camera.
Incorrect voltages will damage the camera.
MAN077 11/2017 V1.0
- t h e r n e t J a c k ( R J 4 5 )
7
P o w e r S u p p l y
a n d I / O
C o n n e c t o r
89 of 139
Advertisement
Table of Contents
