Hardware Interface
15.1 Absolute Maximum Ratings
Parameter
Camera Control Input Signal Voltage Single Ended
Camera Control Output Signal Voltage Single Ended
Camera Control Output Signal Output Current Single Ended
Camera Control Output Signal Output Power Single Ended
ESD Contact Discharge Camera Control Signals
ESD Air Discharge Camera Control Signals
Fast Transients/Bursts Data and Camera Control Signals
Surge immunity Data and Camera Control Signals
Maximum Installation Altitude
Table 15.1: Absolute Maximum Ratings
15.2 Electrical Characteristics
Table 15.2 shows the electrical characteristics of the single ended input.
Table 15.2: Electrical Characteristics
15.3 GigE Camera Connector
The GigE cameras are interfaced to external components via
•
an x-coded M12 connector to power the camera (PoE) and to transmit configuration,
image data and trigger.
•
a 4 pole Binder M5 x 0.5 connector for one I/O input and one I/O output.
The connectors are located on the back of the camera. Fig. 15.1 shows the plugs and the status
LED which indicates camera operation.
15.4 Power Over Ethernet (PoE)
Device: PoE compliant according to IEEE 802.3af standard Class: 2: (3.84-6.49W) supported
Mode: Mode A and Mode B Maximum working voltage according to Standard: 57V at PD side
MAN083 08/2020 V1.2
Parameter
Camera Control Input Single Ended
Value
0 V ... +24 V
0 V ... +24 V
0.1 A
0.15 W
4 kV
8 kV
2 kV
1 kV
2000m above sea level
Value
+5 V ... +20 V
15
97 of 129