Table of Contents
Advertisement
Figure 45. Removing the drive backplane
Next steps
1.
Replace a drive backplane.
2. Follow the procedure listed in
Installing the drive backplane
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the front
bezel..
4.
Remove the air shroud.
5.
Remove all the drives.
Steps
1. Align the slots on the backplane with the hooks on the system.
2. Lower the drive backplane into the system until the release pin locks in place, securing the drive backplane to the system.
3. Connect the data, signal, and power cables to the backplane.
68
Installing and removing system components
After working inside your
system.
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
