Table of Contents
Advertisement
Next steps
1.
Replace an expansion card.
2.
Install the air shroud.
Installing an expansion card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Open the expansion card retention latch.
2. Remove the existing expansion card or filler bracket from the slot.
NOTE:
Store this bracket for future use. Filler brackets must be installed in empty expansion-card slots to maintain
FCC certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and
airflow inside the system.
3. Holding the card by its edges, align the card with the expansion card connector on the system board.
4. Insert the card firmly into the expansion card connector until the card is firmly seated.
5. Close the expansion card retention latch by pushing the latch down until the latch snaps into place.
Figure 58. Installing an expansion card
80
Installing and removing system components
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
