Table of Contents
Advertisement
Option
Description
UEFI Compliance
Specifies the UEFI compliance level of the system firmware.
Version
Memory Settings
You can use the Memory Settings screen to view all the memory settings and enable or disable specific memory functions, such as
system memory testing and node interleaving.
Viewing Memory Settings
To view the Memory Settings screen, perform the following steps:
Steps
1. Power on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE:
If the operating system begins to load before you press F2, wait for the system to finish booting, and then
restart the system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click Memory Settings.
Memory Settings details
About this task
The Memory Settings screen details are explained as follows:
Option
Description
System Memory
Specifies the memory size in the system.
Size
System Memory
Specifies the type of memory installed in the system.
Type
System Memory
Specifies the system memory speed.
Speed
System Memory
Specifies the system memory voltage.
Voltage
Video Memory
Specifies the amount of video memory.
System Memory
Specifies whether the system memory tests are run during system boot. Options are Enabled and Disabled. This
Testing
option is set to Disabled by default.
Memory Operating
Specifies the memory operating mode. This option is set to Optimizer Mode by default.
Mode
Current State of
Specifies the current state of the memory operating mode.
Memory Operating
Mode
NOTE:
The Memory Operating Mode option can have different default and available options based
on the memory configuration of your system.
PowerEdge T340 Pre-operating system management applications
23
Advertisement
Table of Contents
