Table of Contents
Advertisement
Steps
Slide the drive blank into the drive slot until the release tab clicks into place.
Figure 29. Installing a drive blank
Next steps
1.
Replace the front bezel.
2. Follow the procedure listed in
Removing a drive carrier
Prerequisites
1. Follow the safety guidelines listed in
2.
Remove the front bezel.
3. Using the management software, prepare the drive for removal.
If the drive is online, the green activity or fault indicator flashes while the drive is turning off. When the drive indicators are off, the
drive is ready for removal. For more information, see the storage controller documentation.
CAUTION:
Before attempting to remove or install a drive while the system is running, see the documentation for the
storage controller card to ensure that the host adapter is configured correctly to support drive removal and
insertion.
CAUTION:
To prevent data loss, ensure that your operating system supports drive installation. See the
documentation supplied with your operating system.
Steps
1. Press the release button to open the drive carrier release handle.
2. Holding the handle, slide the drive carrier out of the drive slot.
NOTE:
If you are not replacing the drive immediately, install a drive blank in the empty drive slot to maintain proper
system cooling.
After working inside your
system.
Safety
instructions.
Installing and removing system components
53
Advertisement
Table of Contents
