Table of Contents
Advertisement
Option
Description
Integrated Devices
You can use the Integrated Devices screen to view and configure the settings of all integrated devices including the video controller,
integrated RAID controller, and the USB ports.
Viewing Integrated Devices
To view the Integrated Devices screen, perform the following steps:
Steps
1. Power on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE:
If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click Integrated Devices.
Integrated Devices details
About this task
The Integrated Devices screen details are explained as follows:
Option
Description
User Accessible
Configures the user accessible USB ports. Selecting Only Back Ports On disables the front USB ports; selecting
USB Ports
All Ports Off disables all front and back USB ports;
The USB keyboard and mouse still function in certain USB ports during the boot process, depending on the
selection. After the boot process is complete, the USB ports will be enabled or disabled as per the setting.
Internal USB Port
Enables or disables the internal USB port. This option is set to On or Off. This option is set to On by default.
iDRAC Direct USB
The iDRAC Direct USB port is managed by iDRAC exclusively with no host visibility. This option is set to ON or
Port
OFF. When set to OFF, iDRAC does not detect any USB devices installed in this managed port. This option is set
to On by default.
Embedded NIC1
and NIC2
Enables or disables the Embedded NIC1 and NIC2 options. If set to Disabled, the NIC may still be available for
shared network access by the embedded management controller. The embedded NIC1 and NIC2 options are only
available on systems that do not have Network Daughter Cards (NDCs). The Embedded NIC1 and NIC2 option is
mutually exclusive with the Integrated Network Card 1 option. Configure the Embedded NIC1 and NIC2 option by
using the NIC management utilities of the system.
28
PowerEdge T340 Pre-operating system management applications
Table 3. UEFI iSCSI Settings screen details(continued)
Option
iSCSI Device1 Settings
NOTE:
Selecting Only Back Ports On and All Ports Off disables the USB management port and also
restricts access to the iDRAC features.
NOTE:
The Embedded NIC1 and NIC2 options are only available on systems that do not have
Integrated Network Card 1.
Description
Enables you to control the configuration of the iSCSI
device.
Advertisement
Table of Contents
