Processor And Heat Sink; Removing The Heat Sink - Dell EMC PowerEdge T340 Installation And Service Manual

Figure 64. Installing the MicroSD card
Next steps
1. Install the IDSDM or vFlash module.
2. Follow the procedure listed in the

Processor and heat sink

Removing the heat sink

Prerequisites
WARNING: The heat sink may be hot to touch for some time after the system is powered down. Allow the heat sink to
cool before removing it.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the air shroud
Steps
1. Using a Phillips #2 screwdriver, loosen the screws on the heat sink in the order below:
a. Loosen the first screw three turns.
b. Loosen the second screw completely.
c. Return to the first screw and loosen it completely.
2. Repeat the procedure for the remaining screws.
3. Lift the heat sink from the system.
86 Installing and removing system components
After working inside your
Safety instructions.
Before working inside your
system.
system.