Flex Bays; Removing A Nvme Drive Bay Or Flex Bay - Dell 7CX5T Installation And Service Manual

2. Lower the cooling fan assembly into the system until the cooling fan connectors engage with the connectors on the system board.
3. Press the release levers to lock the cooling fan assembly into the system.
Figure 56. Installing the middle cooling fan assembly
Next steps
1. Follow the procedure listed in

Flex bays

Removing a NVMe drive bay or flex bay

Prerequisites
NOTE: The procedure to remove the flex bay is identical to removing the NVMe drive bay.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Disconnect the slim optical-drive and the backplane cables.
4. Remove the backplane from NVMe drive bay or the flex
Steps
1. Using the Phillips #2 screwdriver, remove the two screws that secure the NVMe drive bay to the system.
2. Push the release latch down and slide the NVMe drive bay out of the system.
After working inside your system
Safety instructions on page 65.
Before working inside your system
bay.
on page 66.
on page 66.
Installing and removing system components 99