Dell 7CX5T Installation And Service Manual page 47

Option Description
Intel SST-CP Enable Intel SST-CP. This option is displayed if Performance Per Watt (operating system) or Custom (when
OSPM is enabled) system profiles are selected. It is set to Disabled by default.
Configurable TDP Enables you to configure the TDP level. The available options are Nominal, Level 1, and Level 2. This option is set
to Nominal by default.
x2APIC Mode Enables or disables the x2APIC mode. This option is set to Enabled by default.
Number of Cores Controls the number of enabled cores in each processor. This option is set to All by default.
per Processor
Processor Core Specifies the maximum core frequency of the processor.
Speed
Processor Bus Displays the bus speed of the processor.
Speed
Processor n
The following settings are displayed for each processor that is installed in the system:
Option
Family-Model-
Stepping
Brand
Level 2 Cache
Level 3 Cache
Number of Cores
Maximum Memory
Capacity
Microcode
SATA Settings
You can use the SATA Settings screen to view the settings of SATA devices and enable SATA and PCIe NVMe RAID mode on your
system.
Viewing SATA Settings
To view the SATA Settings screen, perform the following steps:
Steps
1. Power on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click SATA Settings.
NOTE: This option is only available on certain stock keeping units (SKUs) of the processors.
NOTE: Depending on the number of processors, there might be up to two processors listed.
Description
Specifies the family, model, and stepping of the processor as defined by Intel.
Specifies the brand name.
Specifies the total L2 cache.
Specifies the total L3 cache.
Specifies the number of cores per processor.
Specifies the maximum memory capacity per processor.
Specifies the microcode.
Pre-operating system management applications 47