Table of Contents
Advertisement
M.2 SSD module
Removing the M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the air
shroud.
4. Remove the BOSS card.
NOTE:
Removing the BOSS card is similar to the procedure for removing an expansion card riser.
Steps
1. Loosen the screws and lift the retention straps that secure the M.2 SSD module on the BOSS card.
2. Pull the M.2 SSD module away from the BOSS card.
Figure 85. Removing the M.2 SSD module
Next steps
1.
Install the M.2 SSD
module.
Installing the M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in
Steps
1. Align the M.2 SSD module connectors with the connectors on the BOSS card.
2. Push the M.2 SSD module until the module is seated firmly on the BOSS card.
3. Secure the M.2 SSD module on the BOSS card with the retention straps and screws.
132
Installing and removing system components
Safety instructions
on page 65.
Before working inside your system
Safety instructions
on page 65.
on page 66.
Advertisement
Table of Contents
